![]() Note : Click a device and then click the CLI tab to access the command line directly. Part 1: Display Router Information Step 1: Display interface information on R1. This is done so that this activity is ready to provide complete output from show commands when the student configures and activates the Ethernet interfaces. ![]() In addition, routing is configured using OSPF. Some of the configurations are not covered in this course but they are provided to assist you in using verification commands.Īnswers Note : The serial interfaces are already configured and active. Note : The routers in this activity are partially configured. Finally, you will use commands to verify and test your configurations. You will then use the Addressing Table to configure router Ethernet interfaces. In this activity, you will use various show commands to display the current state of the router. Part 3: Verify the Configuration Background
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |